![]() ![]() Insert the card, as indicated.Ī new microSD card should be formatted before using. Do not force the card into the slot as it may damage both the camera and the microSD card. There is only one correct direction to insert the microSD card. Do not over tighten as it will be difficult to remove. Make sure that the X-Sight HD is turned OFF before inserting the card into the slot. Remove X-Sight HD has microSD, microUSB and Micro HDMI ports cap by unscrewing it counter clockwise.You must have an SD card inserted in the device in order to be able to update the scope with the latest firmware as well as utilize the WiFi mode. X-Sight HD has microSD, microUSB and microHDMI ports. They will provide much longer battery life. We highly recommend using lithium AA batteries. Do not over tighten as it will be difficult to remove the next time you replace batteries. Remove the battery cap by unscrewing it counter clockwise.The X-Sight HD will operate on four AA type batteries. Ensure that all optical surfaces are clean and ready for use. Inspect the scope for obvious evidence of damage to optical surfaces, body, eyecups, operation buttons, etc.If any accessories are missing do not hesitate to contact ATN’s Customer Service at or 1-80. Open box, remove the X-Sight HD and check that content of box that nothing is missing.The following steps must be accomplished prior to each mission where the sight is used. Download this manual (.PDF, 2.20 Mb) Unpacking ![]()
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |